ECUHELP KT200II ECU Programmer is confirmed to read and write the SAGEM S3000 MÉGANE RS 2.0 225CV in Boot Mode.

Overview
Image of ECU S3000

Connection Setup
Connect the KT200II multifunction cable as follows:


Reading the ECU
To read the ECU, follow these steps:

Solder the rainbow flat cable and a link.
Use the driver settings:
→BDM / JTAG MODE
→JTAG RENESAS
→AUD SH xxxxx

Writing the ECU
To write to the ECU, follow these steps:
Connect the white, violet, and bicolor grey/red cables of the multifunction cable.
Make 2 links.
→Use the driver settings:
→TOOL BOOT
→RENESAS
→SH xxxxx BOOT MODE

By following these instructions, you can successfully read and write data to the SAGEM S3000 MÉGANE RS 2.0 225CV using the KT200II in Boot Mode.