One user feedback: using KT200II to read Citroen jumper controller sid 208, get the error "start data reading...ERROR UNLOCK Password Read -Try Tool tricore password” (shown as the following images).



Advice and solution:
First read pass in OBD function. With can pinout. Pass saved automatic in Kt200 folder. After that you can read them boot .
Note: 
Do not look for the password file it is automatically saved in the folder where you will put your flash and eeprom reading there will be a small file named password.

KT200II Wiring Diagram of SIEMENS CONTINENTAL SID208 [ TC1797 INT.F.] - Peugeot,Citroen 
Kit to use:
- Multifunction cable

PASSWORD SEARCH:
Connect the pinout below with multifunction cable.
Use the driver:
→ TOOLS BOOT MODE
→ INFINEON TRICORE Tool Password
→ OBD PASSWORD SID208 PSA
→ Click on “Find Password” and follow the software messages.
Attention: On some SID208 PSA you can find the password only via OBD. 


Now that the password has been found it’s possible to read and write the control unit.

READ AND WRITE ECU:
Connect with the multifunction cable the following pinout and the boot shown below.
Use the driver:
→ TOOLS BOOT MODE
→ INFINEON TRICORE Boot
→ SAK TC1797


Below is an alternative boot method for tools with firmware < D070:


For example, ECUHELP KT200II test report:
Peugeot boxer 2.2hdi 
Sid208 
Password in obd 
R/W in boot mode (security ) 
Egr off dpf off 
Chks